How can I redo what I have done in a project? I messed up my code so I undid for a bit but then realized I went too far. What do I do? I found nothing from Google.

Right click the project editor and click “Redo.” Note: this only works if you haven't previously exited the project editor after making the mistake.

pasta_enjoyer7 wrote:

Right click the project editor and click “Redo.” Note: this only works if you haven't previously exited the project editor after making the mistake.

Thanks, I left the tab open but it only worked once. I will figure it out later.

VannKeagan wrote:

Thanks, I left the tab open but it only worked once. I will figure it out later.

What do you mean “it only worked once?” You might have to keep right clicking and pressing redo to keep restoring your code.

pasta_enjoyer7 wrote:

Right click the project editor and click “Redo.” Note: this only works if you haven't previously exited the project editor after making the mistake.

You can also use Ctrl (command on mac) + Shift + Z

subjectnamehere wrote:

(#5)

pasta_enjoyer7 wrote:

Right click the project editor and click “Redo.” Note: this only works if you haven't previously exited the project editor after making the mistake.

You can also use Ctrl (command on mac) + Shift + Z

Shift isn't needed.

Ambigiously wrote:

subjectnamehere wrote:

(#5)

pasta_enjoyer7 wrote:

Right click the project editor and click “Redo.” Note: this only works if you haven't previously exited the project editor after making the mistake.

You can also use Ctrl (command on mac) + Shift + Z

Shift isn't needed.

Ctrl + Z will undo even further.
You should use Ctrl + Y.

i_eat_coffee wrote:

(#7)
Ctrl + Z will undo even further.
You should use Ctrl + Y.

CTRL+Y doesn't function often, atleast on FF.
Though ig its just me

OP wrote:

Thanks, I left the tab open but it only worked once. I will figure it out later.

Press them both once again, its just that CTRL+(num) will technically lock the site into thinking you are still holding the key.